Inplant Office

Wire-Pak™ modular wiring system

Wire-Pak™ electrical wiring system was introduced in 1984. Wire-Pak™ is a custom designed, modular wiring system that literally snaps together as the building is assembled. The male and female connectors used are directional; thus ensuring the system cannot be assembled incorrectly -- there's no guess work.

All Wire-Pak™ pieces are interchangeable allowing for last minute field alterations. The exception to this are our 3-way switches which must be assembled in accordance to the layout provided.

Note: 3-way switches use circuits C/2 and C/3, no other item can be on C/3 with a 3-way switch.

Wire-Pak™ Specifications:

6 wire system utilizing three separate circuits for 110 volts 20 amps only
Circuit 1 (C/1) typically for outlets uses Red - Hot, White - Neutral, Green - Ground
Circuit 2 (C/2) typically for Lights uses Black - Hot, White - Neutral, Green - Ground
Circuit 3 (C/3) typically for 110v air conditioners or isolated lines uses Blue - Hot, Gray - Neutral, Green - ground
All wiring is 12 gage, THHN type, Stranded copper
All conduit to be 1/2" flexible type, .638 inside diameter, .91 outside diameter
The system conforms to the National Electric Code
All Components are UL Listed and Recognized (UL File no. E86583)
220 volt outlets may be provided as separate runs to the breaker box
Conduit clips are provided for fastening the cabling and junction boxes to the roof. Flex conduit should be fastened every 4-1/2' and within 12" of every junction box or fitting
All cable runs shall not exceed 12' without having a junction box connector
An electrician will only be required to bring power to the building and complete the hook-up at the breaker panel.
No other field wiring will be necessary.
A complete bill of materials and electrical schematic are provided.

Wire-Pak™ Features:

Competitive with conventional wiring.
100% reusable
Easy to install with a "fool proof" design
Future outlets can be added as needs require
UL listed Components
Meets NEC requirements
Accepted by most building codes across the USA.

	Wire-Pak™ Specifications
	Component	Description
	*A-n*	Power entry, pig tail to the breaker panel (always female one side)
	*B-n*	Flex jumper between outlets, lights, etc. (always female)
	*C888*	Universal connector junction box (always male)
	*G-n*	Outlet assembly (always female)
	*F-n*	Switch assembly (always female)
	*H-n*	220 volt direct wire outlet assembly (always pig tail)
	n = represents the length of the component

Warnings:
Risk of fire or electrical shock. Do not electrically connect any panel or assembly to more than one supply source. Always determine that each panel or assembly is connected to one and only one electrical power source. Note: The only known areas where this product is not acceptable by code is Cook County, Illinois. Los Angeles County, California requires county approval for all electrical systems, the expense does not justify having this. It is the responsibility of the purchaser to check for any local code restrictions.